Page 1 of 1
building a jdm gsr
Posted:
Sun Dec 18, 2011 2:27 amby JDM FERIO MAN
Hay can I use p30 b16a pistons on stock gsr rods and crank with bc stage 3 na cams and ferra hi comp valves help me out plz thank you
Posted:
Sun Dec 18, 2011 3:05 amby dbrooks
If you run B16 pistons, it's going to raise your compression. It has been done, but I don't know how reliable it is. Good luck
I'd rather go with something made for the block (i.e. forged pistons)
Posted:
Sun Dec 18, 2011 6:00 amby JDM FERIO MAN
I used jdm b16a pistons in my old gsr thats not what im asking I am building a gsr for a friend and he go bc cames aka stage 3 na cams and bc valve springs and ferra valves with the b16 pistons sit to close to the valves or will it be ok lol I dont mess with hondas no more haha so I for get shit
Posted:
Sun Dec 18, 2011 8:29 amby bks84
Do it right, clay it for clearance. Otherwise, slap it together and hope for the best.
Posted:
Sun Dec 18, 2011 3:44 pmby asianrob
im pretty sure it will work with those PR3 pistons,
it might be close with the CTR Pistons but im not sure on that.
Posted:
Sun Dec 18, 2011 7:43 pmby bks84
pretty sure < positive
Clay. The. Motor.
and when you're done doing that...
Degree. The. Cams.