Civic EG

I have a d16z6 in my 93 civic dx sedan and planning to swap it out because
my d16 give up on me. So im picking up a 94 integra Ls motor. I have some B-series Noob Question!!!

Can i use my d-series mounts?
Do I have to change my throttle cable? If i dont will my car still run fine?
The ecu that is coming with the motor is a P06, Will that run right?

Need Help ASAP!! Planning on swapping it on Friday Of this week!!!!!

im not sure if you can use stock d series mounts, but i know you can use the integras stock mounts. make sure you get the correct rear t bracket mount as well.

you can use your stock throttle cable.

if the p06 is chipped with an LS basemap, then yes it will run fine.

is the car an auto? if so then you will need an auto to manual mount.

the stock d mounts will work, the driver side will be either a two or three bolt mounts if its two bolt then you will have to swap out the brackets on the blocks. you will nee the B series, T bracket for the rear mount

you can keep your throttle cable but you'll need to modify the bracket that holds the cable on the manifold.. you can get a b series cable and it will fit right on, thats what i did. it unclips at the pedal without taking the pedal off or apart or anything

MnCivicEg wrote:I have a d16z6 in my 93 civic dx sedan and planning to swap it out because
my d16 give up on me. So im picking up a 94 integra Ls motor. I have some B-series Noob Question!!!

Can i use my d-series mounts? No, have to get B mounts
Do I have to change my throttle cable? If i dont will my car still run fine? Most likely NO, my D cable didnt work. New cable is like 15 bucks anyways. Get from a LS integra.
The ecu that is coming with the motor is a P06, Will that run right? No, that is the ecu for a non vtec D series. P75 is a LS ecu.

Need Help ASAP!! Planning on swapping it on Friday Of this week!!!!!

answered.[/b]