Civic EG

So I'm pulling my obd1 LS setup and putting in an OBD2 LSVtec. I know all the basic stuff, like I'll be putting on my OBD1 alternator, starter and I got a rywire adapter to run the obd2 dizzy. What I need to know is what sensors on the obd2 setup manifold do I need to swap out or what not?? Last time I swapped in a new motor I just put my whole obd1 intake mani/sensors and called it a day. Not happening with this setup

For some reason this little white plug on the bottom of the mani looks unfamiliar, and will I need to switch out any of the other sensors on there??

Thats the IAT sensor.

Alot of, if not all the sensors should swap directly over.

As bk said, all the sensors swap directly over. should be quite easy.

Sweet. Just trying to make sure before it goes. I'm just glad she's not going far. One of my really good friends who's wanted the entire swap since I started even talking about going to a new setup, stepped up big time and showed up the other day with cash.

So I for sure don't need to pluck any of these sensors?? Will I be able to eliminate the evap canister thing since the new edelbrock mani doesn't even have ports for it? Or will I just be able to run the lines that go from it to the fuel filter and plug the ones to the throttle body and intake mani??