Civic EG

Hey can someone give the torque specs for a 99 b18b1 I can't find the specs for the crank caps or the rod caps

B18B1
NON-VTEC
Found in:
1994–2001 Honda Integra "RS/LS/GS/SE/(GSI Australia)" (DC4/DB7)
1992–1996 JDM Honda Domani (MA5)
1993–1994 JDM Honda Inta (DB7)
1996–1999 JDM Honda Orthia (EL1)
Displacement: 1,834 cc (111.9 cu in)
Compression: 9.2:1
Bore: 81 mm (3.2 in)
Stroke: 89 mm (3.5 in)
Rod Length: 137.01 mm (5.394")
Rod/Stroke Ratio: 1.54
Power: 142 bhp (106 kW) @ 6300 rpm & 127 lb·ft (172 N·m) @ 5200 rpm
Redline: 6800 rpm (7200 rpm on JDM Domani)
Rev Limit: 7200 rpm
Transmission: Y80/S80
JDM version is marked B18B on the block without any number.
JDM version has a compression 9.4:1 where the usdm version is 9.2:1.
JDM version has a higher compression ratio which results in higher hp and tq levels than the usdm version.

http://en.wikipedia.org/wiki/Honda_B_engine#B18B1

That had nothing to do with torque specs. Are you using OEM hardware or ARP ?

I'm using OEM hardwear and its the jdm block

22ft lbs, then 56ft lbs on mains.

in this order


14ft lbs then 23 ft lbs on rods.

Thank you so much

sorry it was late at night when i read that on my phone and read it as b18 motor torque spec not what you ment. sorry

It's ok bro but thanks anyways