Civic-EG.com Forum 3.3.1

- Thu Mar 24, 2011 3:52 pm #245895 Hi Guys... I purchased a refurb D15B7 cyl head for my 91 civic (non-vtec) ... I need to set the Valve clearance as the head came with the valve clearance bolts loose. Could someone explain how and when to set it... should I place each cyl. at TDC in order to set the clearance for the respective valves ... or is there a 'how to ..." for setting it ...
I have the settings for the Intake Valve lash at .007-.009 cold (.1) ... and the Exhaust Valve lash at .009-.011 cold (.229-.279) .. Thanks

1992 Honda Civic LX

- Thu Mar 24, 2011 5:24 pm #245907 If you go to the DIY section of the forum, you will see there is one on that matter. Good luck

- Thu Mar 24, 2011 10:44 pm #245962

If you go to the DIY section of the forum, you will see there is one on that matter. Good luck

.. thanks.. I'll try it out.

1992 Honda Civic LX

- Mon Mar 28, 2011 3:18 am #246637

If you go to the DIY section of the forum, you will see there is one on that matter. Good luck

.. thanks.. I'll try it out.

I finally got the valve rocker clearance set right... The engine fired up right away ... Thanks... you have been very helpful..
but .... I am getting alot of white smoke and for that I will open a new thread...

1992 Honda Civic LX