Civic-EG.com Forum 3.3.1

- Wed May 27, 2009 11:03 pm #119060 got a anodized aluminum strut bar.. its red and i'm wondering if i can remove the red to have a polished aluminum look. pretty much want it silver just not by way of paint... can i sand off the red finish?? or should i just by a new silver anodized one?? would it rust/pit without the coating?? maybe spray some urethane or whatever on it??

600whp Turbo 84mm LS/Vtec Drag Hatch

[teal_dx]

- Wed May 27, 2009 11:22 pm #119066 if it's aluminum, just use paint stripper to get it to bare metal. Then if you want, throw some clear coat on it, or use it as bare aluminum. If you use bare aluminum, keep it away from road salt in winter or it will get corrosion on the surface. You may want to polish it from time to time and keep a coat of wax on it.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Wed May 27, 2009 11:27 pm #119067 stripper would remove this to bare metal?


http://cgi.ebay.com/ebaymotors/Rear-Lower-Strut-Bar-Honda-Civic-96-00-97-98-MEGAN-R_W0QQcmdZViewItemQQ_trkparmsZ72Q3a1171Q7c66Q3a2Q7c65Q3a12Q7c39Q3a1Q7c240Q3a1318Q7c301Q3a1Q7c293Q3a2Q7c294Q3a50QQ_trksidZp3286Q2ec0Q2em14QQhashZitem1c09d6cd35QQitemZ120424156469QQptZMotorsQ5fCarQ5fTruckQ5fPartsQ5fAccessories

600whp Turbo 84mm LS/Vtec Drag Hatch

- Fri May 29, 2009 8:24 pm #119601 yup. stripper will remove all of the clear and paint back to bare metal. then you can wet sand watever is left to a polish look or clear it.