Civic-EG.com Forum 3.3.1

- Mon Nov 16, 2009 6:30 am #156762 my d16z6 kind of stutters when it takes off you can feal it wanting to pull but its kind of slugish up until about 3.5k then it just pulls out of it and pulls like it should checked the engine light threw a code 9 cyp could that make my hatch run the way its running? any thoughts

[chrono404]

- Mon Nov 16, 2009 7:13 am #156768 Code 9 is "No.1 Cylinder Position Sensor"

Yes you will want to fix that. If your car is stuttering it can beat your bearings badly which can lead to rod knock. I would highly recommend a qucik repair on these.

2017 Chevy BoltEV DD |2001 Honda CRV SE

- Tue Nov 17, 2009 2:14 am #156871 replace the dizzy, erase code, set timming. and your good

same problem, easy fix

- Tue Nov 17, 2009 6:36 pm #156955 ok well iv been looking around and everywhere says to do the same thing replace the dizzy and set timming now am i supposed to set the timing like redo the timing belt or what?

[teal_dx]

- Tue Nov 17, 2009 8:44 pm #156979 the timing belt is the mechanical timing. be sure everything is at TDC and you're good there.

When they say 'reset timing' or 'check timing' they mean to check the ignition timing with a timing light.

Your Chiltons/Haynes manual will give you all the details on how to do this, or there was a thread not too long ago on here explaining how I think...

edit- here it is:
http://civic-eg.com:/viewtopic.php?t=11 ... ght=timing

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Thu Nov 19, 2009 6:21 pm #157338 alright thanks for the help should be putting it on as soon as it comes