What all fits?

B16, B18, B20
 Reply

What all fits?

By jdmpipedreamd16
- Thu Nov 12, 2009 9:59 pm #156252 I need some parts for my b18a1 and was wondering what from b16a jdm not usdm not sure if it matters will fit my 18 like timing belt water pump tb tenitioner intake sensors and the works really thanks
User avatar

By Dippin_EG
- Thu Nov 12, 2009 11:56 pm #156283 all the sensors should work, possibly the Timing belt and water pump. dnt know for sure
User avatar

By Greasedmonkey
- Mon Nov 16, 2009 6:03 am #156753 if you have the b16a, take these parts

Oil pump
water pump
Pistons
sensors
head w/cams and valvetrain
Intake manifold
Throttle body
Header - if it has one
Tranny


The timing belt will not fit. Dont waste your time trying.

By jdmpipedreamd16
- Tue Nov 17, 2009 7:23 pm #156961 ok so putting all the parts u listed on the b18 what kind of power should i be putting down? Anything close to the 170hp mark the b16a was putting out? and thanks again for all the friendly help and tips :thumb:
User avatar

By JUICE
- Wed Nov 18, 2009 1:32 am #157043 its possible to get that @ the wheels with a good tuned LS-Vtec. especially with a little high comp with those pistons.
User avatar

By Greasedmonkey
- Thu Nov 19, 2009 3:47 am #157253 if done right, and with tuning alot is possible. Ive seen basic ones make 190+
User avatar

By Greasedmonkey
- Sat Nov 21, 2009 2:41 am #157628 Basic ls/v making 190+ b16a pistons, shot peened rods, cams...

By jdmpipedreamd16
- Tue Nov 24, 2009 6:51 pm #158192 ok my orginal question was will the sensors from my 92 jdm (not usdm) 170hp b16a (u know out of the integra xsi :twisted: ) fit on my usdm b18a1?? well i found out that it will NOT fit so i have an issue my icv is bad can i try and clean it or just shell out for a new one??? thanks again!
User avatar

By Greasedmonkey
- Thu Nov 26, 2009 6:04 pm #158555 IACV you can clean out. they also should swap around. and over from car to car, as long as its the same style.
 Reply
Return to B Series