Civic-EG.com Forum 3.3.1

- Sun Nov 22, 2009 11:00 pm #157868 Im replacing the quarter panels on my hatch and am curious how to go about fixing the wheel wells? Is there any aftermarket wheel wells I can by or can I just weld a piece in ?

http://tinypic.com/r/29yl5xl/6

http://tinypic.com/r/2ai3dky/6

http://tinypic.com/r/191d1x/6

http://tinypic.com/r/2v92d69/6

http://tinypic.com/r/2n6x4k6/6

http://tinypic.com/r/dpv40z/6

- Mon Nov 23, 2009 12:50 am #157884 unless you can get ahold of another hatch to cut it from, it'll have to be fab'd

600whp Turbo 84mm LS/Vtec Drag Hatch

[teal_dx]

- Mon Nov 23, 2009 1:59 am #157895 I fab'd some patches of mine, they were not as bad as yours though.
That area does not have to look pretty, just be complete & sealed to get the job done.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Mon Nov 23, 2009 2:43 am #157906 Teal what did you use to seal it?

- Mon Nov 23, 2009 3:18 am #157908 teals DIY.... http://civic-eg.com/viewtopic.php?t=24




make sure to check out the DIY section! here...http://civic-eg.com/viewtopic.php?t=1474

600whp Turbo 84mm LS/Vtec Drag Hatch

[teal_dx]

- Mon Nov 23, 2009 3:52 am #157913 I used a 3M automotive seam sealer. It's like a tube of calk, thick nasty stuff!

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Sat Dec 05, 2009 5:33 am #160099 does anyone know if wheel wells from a 4 door will fit a hatch ???

http://rustrepair.com/index-mf.html

- Wed Dec 09, 2009 6:43 am #160763 damn i have the same problem as you hey if you find some after market ones please let me know !!!!