Civic-EG.com Forum 3.3.1

- Fri Dec 11, 2009 6:24 pm #161333 does any 1 know wut i have to modify and also andy additional parts i would need to put in an s2000 ep3 fit or 06 and above civic steering wheel in my cx hatch

- Fri Dec 11, 2009 6:39 pm #161338 I'd like to actually know if this could be done.

282hp 235tq on Dyno Dynamics w/ 50 shot nitrous

232hp 189tq on Dyno Dynamics
http://www.civic-eg.com/viewtopic.php?t=3903

Del sol Build
http://www.civic-eg.com/viewtopic.php?t=3157

- Thu Feb 11, 2010 6:28 pm #174692 anyone with info on how to do this ???

1994 CIVIC Lx Camellia red pearl ( purple)

- Fri Feb 12, 2010 9:54 am #174832 From what i have heard none will fit without custom fabrication.
Get a dc2 wheel as they go straight on.

- Fri Feb 12, 2010 4:07 pm #174859 i found this on club civic

http://www.clubcivic.com/board/showthread.php?t=182091

it looks really good.

- Fri Feb 12, 2010 5:34 pm #174889 do you plan on doing this saadi?? if so make sure to post up some photos

- Fri Feb 12, 2010 5:43 pm #174892 that would not work. ek9 (96-00) spline is very different.
Actually if you look at the nrg website, their hubs come for eg/dc and ek9/ep3/s2k. this means that s2k and ek9 splines are same, while eg is different and only shares spline with DC brethrens.
Hope this helps!

Engine Parts For Sale Thread

- Mon Feb 15, 2010 12:43 am #175367 I want to have one of the steering wheels that can be taken off, similar to the race car-ish steering wheels. Just a thought.

- Mon Feb 15, 2010 12:52 am #175368 yeah you would have to swap out the steering column from an ek or dc, theres no fabrication you just swap them out. i know this cus i asked the same question before about an ep3 steering wheel hope this helps

#11 member coupe crew

BurqueB16's Build