Civic-EG.com Forum 3.3.1

- Wed Jan 20, 2010 5:26 am #169689 when u put the wire in the clip to check ur check engine light do you unplug the plug and put the wire in where you took the plug out or put the wire in with it plugged in?

- Wed Jan 20, 2010 7:39 am #169720 Wat!

You unplug it and put the wire in the part with the clip part.

- Wed Jan 20, 2010 4:30 pm #169764 WTF dude you need to read what you typed cause it looks like you were typing faster than you could think. i have no fucking idea as to what your question is.

Hatch http://civic-eg.com/viewtopic.php?t=27660
Sedan(gone) http://civic-eg.com/viewtopic.php?t=7462

[teal_dx]

- Wed Jan 20, 2010 5:12 pm #169770 not sure exactly what you're asking, but just follow these directions:
http://civic-eg.com/viewtopic.php?t=1558

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Wed Jan 20, 2010 6:47 pm #169787 my bad fellas but i figured it out lol sorry for the mix up

- Wed Jan 20, 2010 10:30 pm #169844 i must be dumb but r something because i took the plug out and put the wire in dadada and the light blinks but if i take out the wire it blinks the same i must be doing something wronge lol....i dont get it....and if i read it it would be cel# 10 the iat...would that have nething to do with the idle in my whip?

[teal_dx]

- Thu Jan 21, 2010 2:18 pm #170030 maybe it wasn't contacting in both of the terminals

Check out your IAT, is it plugged in, wires all good?
It's the white sensor on the back of the intake manifold.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage