Civic-EG.com Forum 3.3.1

- Mon Jan 25, 2010 5:57 am #170914 I wanted to know if I would be able to mill my head .025 mm and would the result be higher compression??

Uno cam thuggin

[chrono404]

- Mon Jan 25, 2010 6:01 am #170915 if it hasn't been done already then yes, and your compression would go from 9.14:1 to 9.16:1 Assuming you have a stock engine.

2017 Chevy BoltEV DD |2001 Honda CRV SE

- Mon Jan 25, 2010 6:05 am #170917 wat about .040 mm ?? with adjustable cam gear and deck about .020 mm ?

Uno cam thuggin

[chrono404]

- Mon Jan 25, 2010 6:58 am #170922 d series compression calculator

IT calculates your compression, you will need to convert your .025mm and .040mm to inches, Google will convert it when you type in .025mm to inches

2017 Chevy BoltEV DD |2001 Honda CRV SE

- Mon Jan 25, 2010 4:09 pm #170965 z6/d15b vtec head can go -.06 with a big cam with p28 or p08 piston.
any farther and you will most likely need deeper valve reliefs, depending on your cam.
vtec heads are a pain to 'clay'

street machines > dyno queens
z6 turbo power FTW tuned on crome

- Mon Jan 25, 2010 5:50 pm #170978 yea ok well I wanna try to get a lil more compression do I have to put in a bigger cam or could i just do a mild mill ?

Uno cam thuggin

- Tue Jan 26, 2010 3:56 am #171123 a cam will not affect your compression.
but it can open your valves more, bringing them closer to the piston.

street machines > dyno queens
z6 turbo power FTW tuned on crome