- Mon Jan 25, 2010 9:34 pm
#171018
check out my boy milks cone(aka ikon known on this forum) 
[/quote]
[/quote]
- Mon Jan 25, 2010 9:39 pm
#171026
ya i seen the cone. not the first time tho. would be funny if it was a jiant cigarette
what about a giant white eg sedan with red rims ??? 
- Mon Jan 25, 2010 9:49 pm
#171034
haha. yall are crazy
{ikon}EM1 wrote:yea me too!!! all the time but he never wins.man egsedanguy your sooooooooooooooooooooo cool
haha. yall are crazy
- Fri Mar 05, 2010 9:19 am
#179320
can you walk me through the rusting process, cause i gots a spare one and its beat up so might as well fuck around lol
- Fri Mar 05, 2010 1:07 pm
#179336
just go balls to the wall with a grinder/sander/paint stripper to get it down to bare metal and let nature take it's course
95 Civic Coupe DX - d15b7 - some mods nothing crazy - My 5th EG
98 Jeep Cherokee 2 door - little lift with 31s 4.0 5 speed
77 Chevrolet C10 - Mild 350/350 combo - lowered a little
98 Jeep Cherokee 2 door - little lift with 31s 4.0 5 speed
77 Chevrolet C10 - Mild 350/350 combo - lowered a little
- Fri Mar 05, 2010 1:49 pm
#179343
I like cones...
Now on to my thread jack.
I used to do metal art for Studio Iron in gilbert and this is what I did...
Use Muriatic Acid.
I use very diluted acid/water mix and apply it to the cold metal let it sit for about 24ish hours and it will be pretty covered with rust
(I personally used a torch to heat it up which RAPIDLY speeds up the process and also allows you to change the color of the rust from light orange to a dark purple, BUT DO NOT HEAT UP YOUR HOOD!).
Then for a hood... spray the metal down with warm water only (add a little salt to speed things up) three to four more days. The water baths remove most of the acid compound. The metal will continue to rust and pit so you have to stop the process at the desired aesthetic. I use hydrogen peroxide the 99% stuff to stop the chemical process (I Learned this lil tip/trick in chemistry ;) ).
Now on to my thread jack.
DontHateonEG8 wrote:can you walk me through the rusting process, cause i gots a spare one and its beat up so might as well fuck around lol
I used to do metal art for Studio Iron in gilbert and this is what I did...
Use Muriatic Acid.
I use very diluted acid/water mix and apply it to the cold metal let it sit for about 24ish hours and it will be pretty covered with rust
(I personally used a torch to heat it up which RAPIDLY speeds up the process and also allows you to change the color of the rust from light orange to a dark purple, BUT DO NOT HEAT UP YOUR HOOD!).
Then for a hood... spray the metal down with warm water only (add a little salt to speed things up) three to four more days. The water baths remove most of the acid compound. The metal will continue to rust and pit so you have to stop the process at the desired aesthetic. I use hydrogen peroxide the 99% stuff to stop the chemical process (I Learned this lil tip/trick in chemistry ;) ).