Civic-EG.com Forum 3.3.1

- Sat Jul 17, 2010 10:18 pm #205135 i just got some of these bad boys for a b16a.

the paper on the inside says to tq to 80ft lbs...

the oem spec says like 22 then 61.

should i then go a third step to 80?

this is a stock motor btw nothing fancy.

any info as soon as possible would be helpfull THANKS GUYS!!':thumb:

"remember rule number one" "rubber side down"

http://civic-eg.com/viewtopic.php?t=12122

- Sat Jul 17, 2010 10:54 pm #205139 Yea do it in steps, then After a couple days re check the torque.