b16a axles!!!!!

B16, B18, B20
 Reply
User avatar

b16a axles!!!!!

By intheworks
- Mon Oct 04, 2010 11:35 am #216731 i have a 92 civic hatch with a b16a obd1. Needed a axle so i went to autozone and pick up a em1 axle. so here is the problem:

where it hooks up to the halfshaft it is not tight on there, so when i give it gas it shakes. What axles should i try?? i already tryed 2 em1 autozone axles!!!
User avatar

By Eg6H2D
- Thu Oct 07, 2010 8:25 pm #217365 Slap on GSR axles..
should be a perfect fit..

EG+DC share the same chassis plus many interchangeable parts..

EG+EK(EM1) Dont really mix.. lol.
User avatar

By chrono404
- Fri Oct 08, 2010 2:31 am #217418 I'm Running Em1 b16 axles in my b20/b16 tranny delsol and have no issues. However the only reason I have them is the swap use to be in an EK hatch.
User avatar

By Greasedmonkey
- Fri Oct 08, 2010 3:15 am #217426 DC/EK axles are the same. Ive got a mix of them on mine as it is.

Make sure you have the axle seated all the way.
User avatar

By intheworks
- Fri Oct 08, 2010 11:44 am #217489 thanks for the replies!! ill try 95 integra gsr!! i tryed 2 em1 axles from auto zone and made sure it clicked into position on the half-shaft!! Both wobbled at the half shaft!!
User avatar

By Greasedmonkey
- Fri Oct 08, 2010 6:03 pm #217529 check and make sure the halfshaft is still good.
User avatar

By intheworks
- Fri Oct 08, 2010 6:19 pm #217535 what can i do to check the half-shaft? i mean it looks ok
User avatar

By Greasedmonkey
- Fri Oct 08, 2010 6:36 pm #217538 the axles shouldnt wobble in it. they should fit tight.
User avatar

By intheworks
- Fri Oct 08, 2010 7:26 pm #217547 the axles that came with the swap were original to the motor, it fits in the half shaft perfect but its just those autozone em1 axles didnt fit tight
User avatar

By Eg6H2D
- Fri Oct 08, 2010 8:10 pm #217557 get an ebay set.. =] or advanced auto.. pep boys..
 Reply
Return to B Series