Civic-EG.com Forum 3.3.1

- Tue Oct 12, 2010 10:00 pm #218113 So i went to change my transmission fluid today and this is what i find...faaack









any ideas on getting these bad boys out would be awesome guys, the nuts are completely rusted to the washers too, when i get these off where can i grab new ones/what are the specs on them

- Tue Oct 12, 2010 11:35 pm #218120 pb blaster patience and a good 6pnt socket and good socket wrench

1980 volvo 242
2001 crv
not using punctuation or good sentence structure since day 1

- Wed Oct 13, 2010 12:23 am #218125 Get some Skunk2 or PWJDM or MFactory or whatever Magnetic drain plugs, the fill plug will have to be either from a dealer or a junkyard or wherever you can find it.

Since the trans case is aluminum, they should just spin right out, but just to be safe, hit it with PB for a few hours. Tap the bolts with a hammer or mallet while spraying them.

Hi, I'm John. I'm a hacky sackin', rock climbin', scuba divin', aircraft mechanic.

- Wed Oct 13, 2010 1:13 am #218128 they will come out. they are tick enought. 3/8 breaker bar. that one will come out with no issue. the fill might strip a bit. but should come off . did you try to take em off yet or didnt even bother. Get new ones at the dealer...

Team XXX Racing/WGHonda
My Build Thread EG#1 --> http://civic-eg.com/viewtopic.php?p=115 ... ht=#115778
EG#2--> http://civic-eg.com/viewtopic.php?t=23264
H2D--> http://civic-eg.com/viewtopic.php?t=192 ... ght=#19294

- Wed Oct 13, 2010 4:55 am #218144 honestly could not get them off and didn't have any pb blaster or lube at the house, i tried tapping the socket with a hammer too to try and loosen it and nothing, i was cranking my ass off trying to get them out but not even a budge