Civic-EG.com Forum 3.3.1

- Thu Mar 08, 2007 11:36 pm #2852 What piston and rods would you guys recomend? I am planning to boost my b18a1 and would like peoples opinion on what pistons are the best bang for the buck. Thanks

[ChicagoMike]

- Thu Mar 08, 2007 11:46 pm #2853 AEBS sleeves
Eagle rods
CP pistons
I like OEM bearings too.

------> ALL MOTOR <------
♫ d(-.-)b TRANCE d(-.-)b ♫

- Fri Mar 09, 2007 12:50 am #2854

AEBS sleeves
Eagle rods
CP pistons
I like OEM bearings too.

i heard good ratings on eagle rods and cp pistons

TEAM OUTKAST since AUG 2007

NORCALTUNERS.COM
CIVIC-EG.COM

[ChicagoMike]

- Fri Mar 09, 2007 1:43 am #2855

AEBS sleeves
Eagle rods
CP pistons
I like OEM bearings too.

i heard good ratings on eagle rods and cp pistons

Hahahaha, thats the same set up as my new block, only mines all motor.

------> ALL MOTOR <------
♫ d(-.-)b TRANCE d(-.-)b ♫

- Fri Mar 09, 2007 2:48 am #2864 How much would it be to get a set of cp pistons for a b18a1?

[ChicagoMike]

- Fri Mar 09, 2007 3:16 am #2868 Stock bore I take it?? What compression ratio are you thinking?

------> ALL MOTOR <------
♫ d(-.-)b TRANCE d(-.-)b ♫

- Fri Mar 09, 2007 4:15 am #2869 yes stock bore, I heard 9 to1 was good. What would you recomend?

[ChicagoMike]

- Fri Mar 09, 2007 1:45 pm #2883 9-1 would be perfect! If you're gonna go as far as to get pistons and rods....might as well have the block sleeved. Better safe than sorry, plus you could really crank up the boost then.

------> ALL MOTOR <------
♫ d(-.-)b TRANCE d(-.-)b ♫