Civic-EG.com Forum 3.3.1

- Sat Dec 01, 2012 12:23 am #321298 Does anyone know where I can buy a pair of the hatch support lifts? From what the guy I bought my hatch from told me, the original lifts(I still have them) work, but I guess nuts are stripped, would I have to buy new lifts or just simply can go to the hardware store and buy new nuts for them?

- Mon Dec 03, 2012 3:12 pm #321421 They are actually a stud with a hex to tighten them. If they are truly stripped, you'll just have to buy new shocks unless you want to get really crafty and remove the snap ring and the ball stud and match it to a new one. You can get them new from Honda, but they are spendy. You can also find them online used, just look around.

http://www.hondapartsdeals.com/hpa_part ... oupID=7405

[Apexracing]

- Mon Dec 03, 2012 3:44 pm #321430

Does anyone know where I can buy a pair of the hatch support lifts? From what the guy I bought my hatch from told me, the original lifts(I still have them) work, but I guess nuts are stripped, would I have to buy new lifts or just simply can go to the hardware store and buy new nuts for them?

Try a local junk yard, used is much cheaper and you can test them before you purchase

- Mon Dec 03, 2012 7:43 pm #321450 advance auto parts there like 20 bucks each

my shit is runing cuz of this forum

14#COUPE CREW MEMBER
my ricer coupe
http://civic-eg.com/viewtopic.php?p=260106#260106

- Thu Feb 07, 2013 11:51 pm #325853 i purchased OEM as they as painless to install and take out. It does cost a little more.

- Fri Feb 08, 2013 1:34 am #325864 AutoZone $44.99 a pair with a lifetime warranty.

- Mon Mar 18, 2013 1:16 pm #328843 I got a new set of hatch shocks for 30 bucks off eBay. Had them for a few years now and they work great!

92 Civic CX Hatch Project: http://www.civic-eg.com/viewtopic.php?t=16256

- Fri Mar 22, 2013 4:19 am #329146 http://www.ebay.com/itm/Genuine-OEM-Hon ... 8d&vxp=mtr

I got these. Used a little washer to make it flush, otherwise it sits sideways. BTW install the little screws that fit into the glass fittings first, then put the strut on the bolt. It's a bit of a hassle otherwise. Good Luck!